MindsEye Guide | How To Bypass The Power

An effective bypass sequence must be executed with precision to avoid triggering the facility's alarm system. 

This guide outlines each stage of the procedure, detailing how to reroute power without engaging restricted circuits. All components referenced are critical to mission success and must be handled carefully.

Internal Circuitry

To get around the power, the internal circuitry has to be carefully changed so that electricity flows away from safe modules. Accessing the Panel, realigning the conductive lines, and isolating the circuit chip to stop accidental links are all parts of this process. 

If you follow these steps exactly, the Bell will go off to let you know that the rerouting worked, and the rest of the system will stay intact.

Accessing the Panel

Upon reaching the control alcove, remove the protective cover to reveal the Panel. Inside, two primary Lines and the central Circuit are immediately visible. 

The objective at this stage is to establish a direct link between one of the Lines and the Bell without permitting any current to flow into the Circuit Chip. 

It is crucial to maintain power until alignment is achieved; disconnecting prematurely will trigger the Alarm system. Scrutinize each segment to identify attachment points for the Lines.

Rotating the Circuit Board

The Board is made up of several pieces that fit together and are held together by small rivets. Watch the Lines as they move along the conductive tracks as you slowly rotate each section. 

Repeat this process until a continuous channel forms, sending power to the Bell. This path must be continuous; any break will stop the flow that is needed, which will delay activation and raise the risk of being caught.

Severing the Connection

After making sure there is a path for electricity to reach the Bell, slide the Line link at the board's far end to disconnect it from the Circuit Chip. 

This action cuts off the unwanted path, successfully isolating systems that are limited while keeping the new circuit going.

The Mission proceeds to the next phase without needing to follow containment procedures, as the Bell can now power itself.

Also, check our MindsEye Review and other guides below:

• MindsEye Guide | Little John's Trailer Location
• MindsEye Guide | Everything You Can Do In Free Roam
• MindsEye Guide | How to Revive Matt Conti (CPR Mini Game Guide)
• MindsEye Guide | How To Power & Align The Satellite
• MindsEye Guide | How To Get To Control Room